Cable Runway E-Bend Creates a 90-Degree Gradual Sweep for Horizontal Cable Ladder Runs The SmartRack SRL90BEND18 allows you to place a curved right angle in your horizontal cable runway application. It connects to your 18-inch cable runway above your rack enclosure or open frame rack to allow flexibility in your overhead cable routing. Install it either parallel or perpendicular to the rack for clean, organized cable routing across an aisle or within a row. Measures 18 in. Wide with a 33 in. Wide Bend This cable E-bend conforms to minimum-bend radius requirements (typically four times the cable diameter). It's made from lightweight tubular steel measuring 1.5 x 0.375 inches (38 x 9.5 millimeters). It fits 18-inch (457-millimeter) cable runway widths, and meets Cat5e/6/6a requirements. Designed for Use with Tripp Lite Rack Cabling Components The SRL90BEND18 ships fully assembled for connecting right out of the package. It's compatible with Tripp Lite's 18-inch SRCABLELADDER18 and SRLBUTTSPLICE kit for toolless assembly. All Tripp Lite accessories are sold separately. Typical Applications Neatly bundle cable across an aisle or within a row of bayed racks in your data center System Requirements Works with SRCABLELADDER18 and SRLBUTTSPLICE